共查询到19条相似文献，搜索用时 906 毫秒
1.
A novel control strategy for the load converter supplying the unbalanced AC load in a DC isolated distribution system is presented. The control algorithm results in balanced and sinusoidal load voltages under unbalanced AC loading. The unbalanced load is characterized in the d-q-0 rotating coordinate based on symmetrical sequence components. Also, the mathematical model of the load converter in both a-b-c and d-q-0 coordinates is derived by using the average large signal model. Then, two control strategies for the load converter are presented. The first one uses the conventional d-q-0 controller to ensure the voltage and current regulation. The second one is a newly proposed control strategy based on the decomposition of the voltage and current into in- stantaneous positive, negative, and zero sequences. These three sequences are controlled independently in their own reference frames as DC signals. The performance of the load converter using these two control strategies is compared. Simulation results show the validity and capability of the newly proposed control strategy. 相似文献
2.
A novel software implementation for current polarity detection and current compensation is presented. For a three-phase zero-voltage soft-switching （ZVS） PWM converter based on phase and amplitude control （PAC）, when saw-tooth carriers with alternate positive and negative slopes are adopted, the positive or negative slopes are chosen according to the phase current polarity. Since polarity reversal causes current distortion, current at the instant of reversal should be compensated for. Based on the characteristic of unity power factor converter in rectification and regeneration modes, a software implementation for current polarity detection is proposed. Distortion of current zero-crossing caused by using saw-tooth carriers with alternate positive and negative slopes is analyzed, and the relevant compensation method is proposed. Experimental study with a 1.5 kW device shows that phase current has a small harmonic content and power factor is high both in rectification and regeneration modes. 相似文献
3.
This paper presents a novel current feedforward control strategy for a three-phase pulse-width modulation (PWM) DC voltage-type converter based on phase and amplitude control (PAC). With right-angle triangle relation of phasors and principle of conservation of energy, a phasor adjustment method and the relevant low-frequency mathematical model of the system are analyzed in detail, both in rectification and regeneration modes for the converter, are discussed. For improving the traditional PAC dynamic performance, variable load current is detected indirectly by the change of the DC voltage, which is fed to the control system as an additional control variable to generate modulation index and phase angle. Also, the algorithm is derived and the system principle is introduced. Experimental results from a 3 kw laboratory device are included to demonstrate the effectiveness of the proposed control strategy. 相似文献
4.
We investigate alternating response of the spin current in a quantum dot system coupled to a normal metal electrode,to which an alternating driving voltage and a pumping rotating magnetic field are applied.The expression of the time-averaged spin current and its differential is obtained based on a non-equilibrium Green's function method.We find that for a given rotating frequency,the spin current increases rapidly and appears to have small steps when the driven frequency increases.As the driven frequency is further increasing,the spin current can be significantly enhanced and approaches a stable value.The photon-assisted processes bring about interesting features of spin current.The influence of the gate voltage and temperature on the spin current is examined in detail. 相似文献
5.
This paper proposes a current control scheme for a grid-connected pulse width modulator （PWM） voltage source converter （GC-VSC） under imbalanced and distorted supply voltage conditions. The control scheme is implemented in the positive synchronously rotating reference frame and composed of a single proportional integral （PI） regulator and multi-frequency resonant controllers tuned at the frequencies of 2ω and 6ω, respectively. The experimental results, with the target of eliminating the active power oscillations and current harmonics on a prototype GC-VSC system, validate the feasibility of the proposed current control scheme during supply voltage imbalance and distortion. 相似文献
6.
This paper presents a novel mega-Hz-level super high frequency zero-voltage soft-switching converter for induction heating power supplies. The prominent advantage of this topology is that it can absorb both inductive and capacitive parasitic components in the converter. The switch devices operate in a zero-voltage soft-switching mode. Consequently, the high voltage and high current spikes caused by parasitic inductors or capacitors oscillation do not occur in this circuit, and the high power loss caused by high frequency switching can be greatly reduced. A large value inductor is adopted between the input capacitor and the switches, thus, this novel converter shares the benefits of both voltage-type and current-type circuits simultaneously, and there are no needs of dead time between two switches. The working principles in different modes are introduced. Results of simulation and experiments operated at around 1 MHz frequency verify the validity of parasitic components absorption and show that this convener is competent for super high frequency applications. 相似文献
7.
This paper presents a multi-mode control scheme for a soft-switched flyback converter to achieve high efficiency and excellent load regulation over the entire load range. At heavy load, critical conduction mode with valley switching （CCMVS） is employed to realize soft switching so as to reduce turn-on loss of power switch as well as conducted electromagnetic interference （EMI）. At light load, the converter operates in discontinuous conduction mode （DCM） with valley switching and adaptive off-time control （AOT） to limit the switching frequency range and maintain load regulation. At extremely light load or in standby mode, burst mode operation is adopted to provide low power consumption through reducing both switching frequency and static power dissipation of the controller. The multi-mode control is implemented by an oscillator whose pulse duration is adjusted by output feedback. An accurate valley switching control circuit guarantees the minimum turn-on voltage drop of power switch. The prototype of the controller IC was fabricated in a 1.5-μm BiCMOS process and applied to a 310 V/20 V, 90 W flyback DC/DC converter circuitry. Experimental results showed that all expected functions were realized successfully. The flyback converter achieved a high efficiency of over 80% from full load down to 2.5 W, with the maximum reaching 88.8%, while the total power consumption in standby mode was about 300 mW. 相似文献
8.
This letter presents a multi-frequency proportional-resonant (MFPR) current controller developed for PWM voltage source converter (VSC) under the unbalanced supply voltage conditions. The delta operator is used in place of the shift operator for the implementation of MFPR by using a low-cost fixed-point DSP. The experimental results with an alternative control strategy validated the feasibility of the proposed MFPR current controller for the PWM VSC during voltage unbalance. 相似文献
9.
This paper presents a powerful application of genetic algorithm （GA） for the minimization of the total harmonic current distortion （THCD） in high-power induction motors fed by voltage source inverters, based on an approximate harmonic model. That is, having defined a desired fundamental output voltage, optimal pulse patterns （switching angles） are determined to produce the fundamental output voltage while minimizing the THCD. The complete results for the two cases of three and five switching instants in the first quarter period of pulse width modulation （PWM） waveform are presented. Presence of harmonics in the stator excitation leads to a pulsing-torque component. Considering the fact that if the pulsing-torques are at low frequencies, they can cause troublesome speed fluctuations, shaft fatigue, and unsatisfactory performance in the feedback control system, the 5th, 7th, 1 lth, and 13th current harmonics （in the case of five switching angles） are constrained at some pre-specified values, to mitigate the detrimental effects of low-frequency harmonics. At the same time, the THCD is optimized while the required fundamental output voltage is maintained. 相似文献
10.
Voltage source converter high-voltage direct current （VSC-HVDC） is a new power transmission technology pref- erable in small or medium power transmission. In this paper we discuss a new control system based on space vector modulation （SVM） without any voltage line sensors. Using direct power control （DPC） SVM and a new double synchronous reference frame phase-locked loop （DSRF-PLL） approach, the control system is resistant to the majority of line voltage disturbances. Also, the system response has accelerated by using a feed forward power decoupled loop. The operation of this control strategy was verified in a SIMULINK/MATLAB simulation environment. To validate this control system, a 5 kV.A prototype system was constructed. Compared to the original controllers, the current total harmonic distortion （THD）, the active and reactive deviations and the DC voltage overshoot were lowered by 2.5%, 6.2% and 8%, respectively. The rectifier power factor in the worst condition was 0.93 and the DC voltage settling time was 0.2 s. 相似文献
11.
结实型谐振支路及其在软开关变换器中的应用 总被引：1，自引：0，他引：1
本文给出了结实型谐振支路实现软开关的工作原理和运行特性 ,详细讨论了结实型谐振支路拓扑在软开关直直变换器和软开关逆变器中的各种应用 .结实型谐振支路可构成升降压软开关直直变换器、具有输出功率自动限制特性的隔离型软开关直直变换器 ,可实现部分串联谐振直直变换器功率管的零电压、零电流开关 ,可用于移相控制全桥直直变换器实现滞后桥臂功率管的软开关 ,可构成结实型谐振极逆变器和结实型谐振直流环节逆变器 .本文对各变换器的工作原理、特性、实现软开关的条件进行了讨论 ,给出了实验和仿真波形 . 相似文献
12.
在对微波炉磁控管进行伏安特性研究的基础上,设计了一种可调恒流开关电源,其最高输出电压为4 200V,额定输出功率为1 200W,输出电流0～270mA连续可调,以其取代传统的恒压源来驱动微波炉磁控管,阐述了其设计方法及测试结果。 相似文献
13.
14.
本文提出了一种LCL谐振式推挽电路拓扑,谐振元件位于推挽电路变压器的原边;分析了电路的两种工作模式,通过分析可知,谐振电路参数决定谐振频率,同时影响谐振电流幅值;以600W样机为基础,进行了仿真分析与实验,实验表明提出的电路拓扑很好地实现了零电压开通和零电流关断,验证了拓扑的正确性和有效性。 相似文献
15.
范国明 《荆门职业技术学院学报》2009,24(9):41-44
文章研究了智能控制技术在通信开关电源系统变换器中的应用。针对变换器为非线性、时变系统的特点,提出了一种模糊自适应PID控制算法。与传统的PID算法相比,该智能控制算法提高了开关电源的动态性能,减小了负载变化时的输出电压恢复时间和电源启动时输出电压的超调量。 相似文献
16.
ZVS（zero voltage switching） PWM（pulse width modulation） inverters have attracted much attention recently. The basic idea is to use ZVS circuit as the main circuit of inverter resonance at the beginning of every carrier period so that each power device can commutate when voltage of the main circuit＇s DC bus line is zero. To ensure the resonant circuit to operate properly, sawtooth with alternate slope （positive or negative） is used as carrier. But the time of zero voltage vectors with such PWM pattern is greatly different from traditional hard-switching PWM pattern. This paper discusses the locus of flux linkage under soft-switching PWM pattern by using space voltage vector. It is pointed out that, under the hard-switching PWM pattern, speed of flux linkage is adjusted by zero space voltage vector. When soft-switching PWM pattern is used, however, effective time of space voltage vector varies considerably, sometimes even without zero space voltage vector. Therefore non-zero space voltage vector has been used to make the speed of flux linkage locus equal to that of hard-switching PWM pattern. The cause of current distortion in soft-switching PWM inverters is also discussed. Based on the flux linkage locus circle, corresponding compensation methods are proposed. Experimental results show that the described method can effectively improve output current waveform of inverter. 相似文献
17.
郑莹莹 《广东广播电视大学学报》2012,21(4):108-111
一种新型氦氖激光器电源以直流12V输入,并采用开关电源逆变、倍压整流等技术;摒弃了传统的大电阻恒流的方式,采用了负反馈电路控制电流,减少了功耗,且稳流精度高于2％;还增加了稳功率电路,稳功率精度可达3％以上。 相似文献
18.
提出一种逐次逼近型模数转换器（successive approximation register analog-to-digital converter,SAR ADC）高能效电荷均值开关方法。该方法能够提供恒定的共模电压VCM,大小为VREF的一半,且只需要使用两个参考电压VREF和地,避免了额外的电压基准电路。为了增加一位精度并保持恒定的共模电压,C-2C结构替代参考电容C。与单调开关方法相比,该方法能耗减少66.65％,电容面积减少49.41％。行为仿真结果证明了该方法的有效性。 相似文献
19.
提出了一种能在全负载范围内实现零电压开关的改进型全桥移相ZVS—PWMDC／DC变换器．该电路简单高效,超前臂、滞后臂都能在很宽的范围实现软开关．介绍和分析了变换器的工作原理,最后给出了实验结果和两个主要波形,并做出了详细的说明． 相似文献