| 16位CRC校验原理与基于PLC的算法程序设计 |
| |
| 引用本文： | 胡惠玉.16位CRC校验原理与基于PLC的算法程序设计[J].常熟理工学院学报,2009,23(10):80-83,88. |
| |
| 作者姓名： | 胡惠玉 |
| |
| 作者单位： | 集美大学,工程技术学院,福建,集美,361021 |
| |
| 摘 要： | 数据在通信线路上传输时，由于各种各样的干扰和噪声的影响，导致接收端可能收到不正确的数据．实际工程中，常用16位CRC校验方式实现工业网络底层PLC与上位PC机通讯系统中数据链路层差错校验．文中分析了CRC校验原理，提出了实现CKC校验的算法，编写了基于西门子S7—200PLC的CRC校验程序．
|
| 关 键 词： | 差错控制 CRC校验 数据链路层 PLC |
16-bit CRC Checksum Principle and Programming Based on PLC |
| |
| HU Hui-yu.16-bit CRC Checksum Principle and Programming Based on PLC[J].Journal of Changshu Institute of Technology,2009,23(10):80-83,88. |
| |
| Authors: | HU Hui-yu |
| |
| Institution: | HU Hui-yu (School of Engineering and Technology, Jimei University, Jimei 351021, China) |
| |
| Abstract: | When data transmission on communications lines, due to a variety of interference and noise, the receiving end may receive incorrect data. In practical engineering of industrial networks, PLC is the bottom controller to communicate with the host computer, CRC checksum is commonly used in data link layer error checking. The paper analyzes the principle of CRC checksum, proposes the algorithm to achieve CRC checksum, and prepares the program based on Siemens S7-200 PLC. |
| |
| Keywords: | PLC |
| 本文献已被 维普 万方数据 等数据库收录！ |
|
