密集多通道陶瓷膜处理乳化液废水的研究 |
| |
引用本文: | 叶兴刚,;李小波.密集多通道陶瓷膜处理乳化液废水的研究[J].十堰职业技术学院学报,2014(4):100-102. |
| |
作者姓名: | 叶兴刚 ;李小波 |
| |
作者单位: | [1]武汉大学资源与环境工程学院,湖北武汉430000; [2]湖北工业职业技术学院环境工程系,湖北十堰442000 |
| |
摘 要: | 针对密集多通道无机陶瓷膜处理汽车发动机乳化液废水开展了中试试验,并通过工程检验,获知该类废水处理的适宜设计参数为:膜面流速取4-6 m/s,压力控制为0.3 MPa,温度控制在45℃左右;在相应的操作条件下,COD、含油量等均达到了后续污水处理的水质要求,效果明显。
|
关 键 词: | 密集多通道无机陶瓷膜 乳化液废水 膜面流速 操作压力 含油量 |
Research of Emulsion Wastewater Treatment with Intensive Multi-channel Ceramic Membrane |
| |
Institution: | YE Xin-gang, LI Xiao-bo ( 1. Resources and Environmental Engineering College, Wuhan University, Wuhan 430000, China ; 2. Environmental Engineering Department, Hubei Industrial Polytechnic, Shiyan 442000, China) |
| |
Abstract: | Intensive multi-channel inorganic ceramic membrane is tested to treat emulsion wastewater of automobile engine , and has passed the engineering inspection .With the Suitable design parameters for this kind of wastewater treatment , namely recircula-tion rate as 4-6 m/s, pressure as 0.3 Mpa, temperature as about 45℃, and under appropriate operating conditions , COD and oil content can reach the quality requirements of following sewage treatment .The effect is obvious . |
| |
Keywords: | intensive multi-channel inorganic ceramic membrane emulsion wastewater recirculation rate operating pressure oil content |
本文献已被 维普 等数据库收录! |
|