首页 | 本学科首页   官方微博 | 高级检索  
相似文献
 共查询到18条相似文献,搜索用时 171 毫秒
1.
介绍了配网中性点接地方式的现状,分析了中性点不接地、经消弧线圈接地、经自动跟踪补偿消弧线圈接地和经电阻接地的特点,并针对配网建设与改造中的不同情况提出建议。  相似文献   

2.
一、消弧线圈的应用工厂供电系统的配电网一般采用中性点不接地的10KV或6KV配电系统.中性点采用不接地方式最简单,单相接地时允许带故障运行两小时,供电连续性好,接地电流仅为线路及没备的电容电流.但电容电流不能超过允许值,例如煤矿6KV配电网不能超过20A,否则接地电弧不易自熄,易产生较高弧光间歇接地过电压,波及整个电网.  相似文献   

3.
煤矿电网是由电缆向井下供电,而且由于煤矿生产的特殊性,要求限制电网的电容电流.因此,准确测量电网各相的对地电容的电流是科学治理的基础.介绍了单相经电阻接地后测量单相接地电流的方法.该方法简单,测试过程安全,测量精度高.实测和仿真表明,采用消弧线圈串联电阻(自动补偿)的运行方式,能有效限制正常运行时中性点位移电压和断线故障时的谐振过电压.  相似文献   

4.
消弧线圈接地电网补偿方式的分析   总被引:2,自引:0,他引:2  
针对消弧线圈接地电网中普遍存在的谐振过电压问题,分析了正常运行及断线故障时各种补偿方式下位移电压的大小,指出了消弧线圈采用过补偿运行方式是防止产生谐振过电压的有效措施。  相似文献   

5.
提出基于EMD和相对能量法相结合的消弧线圈接地系统故障选线方法.通过EMD时空滤波,在故障线路零序电流中提取暂态分量作为特征量,再求得各线路的相对能量,以能量为故障判据,从而检测出故障线路,经Matlab/simdlink仿真验证,结果表明该方法有效,且算法简便.  相似文献   

6.
针对故障发生时接地选线装置难以正确判断接地线路的问题,提出消弧线圈并联中电阻选线系统方案。通过工程应用的效果分析可以看出,此方案较好地解决了10kV配电系统消弧线圈接地选线不准的问题,具有一定的理论及工程应用价值。  相似文献   

7.
为了解决配电网中性点经消弧线圈接地系统单相接地故障选线难、定位难的问题,提出一种基于小波包-贝叶斯的小电流接地故障区域定位方法。首先通过小波包变换获取故障暂态电流信号的频带能比因子、阻抗因子和能谱熵等3个属性,利用加权贝叶斯分类器可准确判别出系统的故障模式。根据所得故障模式即可进一步进行故障选线。在此基础上,利用波形辨识的方法对比各相邻波形间的邻点差异系数,定位出系统的故障位置。通过ATP和MATLAB联合仿真,验证了该方法在此类系统单相接地故障选线与定位中的快速性与有效性。  相似文献   

8.
基于某地区20 k V配电网运行参数,结合该地区电网发展规划,采用PSCAD软件建立相应仿真实验模型。重点研究采用小电阻接地和消弧线圈接地两种不同中性点接地方式下配电网发生单相接地故障时的关键节点电气数据,通过分析实验结果得到其对相关设备和继电保护的影响。为实际电网中性点采用两种接地方式短时切换的可行性提供理论依据。  相似文献   

9.
针对中性点不接地或经消弧线圈接地的小电流接地系统,存在的熄灭接地电弧能力低及系统发生人身感电时、间接性接地过电压时、设备内部故障接地时,无保护能力的问题.在深入研究保护方法的基础上,利用先进的电子技术结合电气原理,将上述系统变为智能接地系统运行的保护方案.同时,介绍了智能接地系统的构成、工作原理、功能与特点及系统运行情况.  相似文献   

10.
提出采用负序电流及故障点损耗能量进行故障选线的新原理,该原理不受中性点接地方式的影响,适用于中性点不接地配电网、经消弧线圈接地配电网,甚至全补偿运行的配电网,该原理适合就地安装,便于在馈线就地控制终端单元(FTU)上实现.原理已经仿真分析及模拟实验论证.,A new principle for grounding fault feeder detection based on negative sequence current variation and energy dissipated in the fault point is presented. It has high precision in both isolated systems and resonance earthed systems, even in full-compensated systems. And it can be installed at the local control unit of feeder in distribution automation systems, such as field terminal unit (FTU). This principle is verified by EMTP simulator and experimentation.  相似文献   

11.
目前,我国城市配电网中电力电缆的应用愈来愈广泛,系统电容电流越来越大,在发生单相接地时电弧不能熄灭,会造成电弧间歇性的熄灭与重燃,形成弧光接地电压或激发磁谐振危及电气设备绝缘,严重时有可能发展为相间短路,引起事故。为限制单相接地故障电流,6-35KV系统采用中性点通过消弧线圈接地来补偿单相接地时的电容电流使电弧熄灭,限制弧光接地过电压和消除铁磁谐振过电压,现已取得较多的运行经验和较好运行效果。  相似文献   

12.
A diagnostic signal current trace detecting based single phase-to-ground fault line identifica- tion and section location method for non-effectively grounded distribution systems is presented in thisi oaper. A special diagnostic signal current is injected into the fault distribution system, and then it is de- tected at the outlet terminals to identify the fault line and at the sectionalizing or branching point along the fault line to locate the fault section. The method has been put into application in actual distribution network and field experience shows that it can identify the fault line and locate the fault section correctly and effectively.  相似文献   

13.
SHORT CIRCUIT CURRENT LIMITER IN AC NETWORK   总被引:13,自引:0,他引:13  
INTRODUCTIONShortcircuitinpowersystemsisaseriousfault,whichmaydamagetheequipmentinthesystem .Itrequirestheprotectionsystemtoswitchofftheveryhighleveloffaultcurrent.Thetraditionalmethodtolimittheshortcircuitcurrentlevelistoseriallyconnectalimitingre act…  相似文献   

14.
The performance of complementary feeders, running in parallel, can be significantly improved by installing static transfer switches (STSs) at critical locations. We develop the STS control logic, which transfers the critical load from the preferred feeder to the alternate feeder when a voltage sag or a fault occurs on the preferred feeder. A forced commutation technique is proposed and implemented to turn off the preferred feeders' thyristor, thus avoiding cross current to flow and minimizing the transfer time. Simulation results show that the forced commutation technique is more effective as compared to the recently proposed time delay technique for STS operation. Two different feeders, namely New Exchange, the preferred feeder, and Sector 1-10/2, the alternate feeder of Islamabad Electric Supply COmpany (IESCO), Pakistan, have been selected for case studies. The software PSCAD/EMTDC professional package has been used for simulation.  相似文献   

15.
Short circuit is a serious fault in power network. Some novel circuit topologies of current limiter using power electronic technology have been developed, which can limit the fault current to any desired level without much penalty. The operating principle and control strategies of such current limiters are discussed in detail. Simulation and experimental results are given to verify the performance of the current limiter, which can meet the requirements set for locations of bus tie, feeder, as well as the main transformer in the distribution network. Project(59777022) supported by National Natural Science Foundation of China(NSFC)  相似文献   

16.
文章依据煤矿井下中央变电所的实际,严格按《煤矿安全规程》要求,探讨了一种应用于煤矿井下(矿用一般型)新型分布式微机监测系统。该系统中的监测装置可对井下中央变电所进线及馈出线电压、电流、功率、功率因数、电度及开关状态进行实时监测,接地保护装置可对接地故障进行实时监测。  相似文献   

17.
通过调试开关站自动跟踪消弧线圈,分析自动跟踪消弧线圈正常运行技术参数,指出设计运行中应注意的问题,保证自动跟踪消弧线圈正常运行,消除弧光接地过电压,保证可靠供电.  相似文献   

18.
点火波形是发动机点火系工作时点火线圈初级、次级电流及电压随时间(或曲轴转角)变化的关系在专用示波器上的显示,它实时反映了点火系的工作状况,次级点火波形分析是现代汽车故障诊断常用方法,对次级点火标准波形及故障波形进行了分析,并以典型的故障波形案例说明了如何运用次级点火波形进行汽车故障诊断。  相似文献   

设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号