排序方式: 共有73条查询结果,搜索用时 31 毫秒
1.
火焰原子吸收光谱法测定废水中不同价态铬的含量 总被引:1,自引:0,他引:1
建立了火焰原子吸收光谱法测定不同价态铬含量的方法。该方法的检出限为0.029mg·L-1;相对标准偏差为0.54%;平均加标回收率为99.3%;利用此分析方法测定了废水中不同价态铬的含量,结果令人满意。 相似文献
2.
利用反应等离子熔覆技术、以Fe-Cr-C-W-Ni合金粉末为原料,在Q235钢表面制得了Cr7C3高铬铁基金属陶瓷增强耐磨复合涂层。利用SEM、EDS和X射线衍射分析了涂层的显微组织,在室温干滑动磨损试验条件下测试了涂层的耐磨性。结果表明:反应等离子熔覆Cr7C3高铬铁基金属陶瓷增强耐磨复合涂层硬度高、组织均匀、与基材之间为完全冶金结合;涂层在室温干滑动磨损试验条件下表现出优异的耐磨性,涂层磨损的质量损失随载荷增加十分缓慢,涂层具有优异的载荷特性。 相似文献
3.
4.
铬是胰岛素发挥生物学作用所必需的微量元素,缺铬可引起胰岛素抵抗,而铬补剂可改善胰岛素抵抗,增加胰岛素靶组织对胰岛素的敏感性,影响机体对葡萄糖的摄取、氧化和糖原合成。就铬对运动机体葡萄糖代谢的影响作一综述。 相似文献
5.
6.
研究不同浓度及不同时间铬离子对泥鳅(Misgurnus anguilliaudatus)的血红细胞核异常的诱导作用。实验结果表明:铬离子对泥鳅红细胞核异常的诱导作用主要表现在引起核质外凸和核质内凹。多数试验组的核异常率高于对照组,显示铬离子对泥鳅红细胞的核异常具诱导作用。各试验组中泥鳅红细胞的核异常率呈一定的波动,在各时间段中随着时间的推移核异常率呈先升高后降低再升高的趋势;不同浓度的试验组诱导作用差异较大。 相似文献
7.
The effectiveness of vitamin C in treating Cr(Ⅵ)-contaminated water is being evaluated. Cr(Ⅵ) is an identified pollutant of some soils and groundwater. Vitamin C, an important biological reductant in humans and animals, can be used to transform Cr(Ⅵ) to essentially nontoxic Cr(Ⅲ). The removal efficiency was 89% when the mass concentration of vitamin C was 80 mg/L in 60 min, and nearly 100% Cr(Ⅵ) was removed when the mass concentration was 100 mg/L. Our data demonstrated that the removal efficiency was affected by vitamin C concentration, the reaction temperature and the dissolved oxygen concentration.The reaction mechanism of Cr(Ⅵ) by vitamin C was presented. Our study opens the way to use vitamin C to remediate Cr(Ⅵ)-contaminated soils and groundwater. 相似文献
8.
INTRODUCTION Chromium is a commonly identified soils andgroundwater contaminant. Cr(VI) is toxic, carcino-genic, and has great subsurface mobility. In contrast,Cr(III) is relatively non-toxic and immobile. Muchresearch focused on the remediation of Cr(VI) such asadsorption by zeolites (Bowman, 2003) or silicas(Hideaki et al., 2002), chemical reduction by ferrousiron (Buerge and Hug, 1999; Fendorf and Li, 1996) orzero-valent iron (Powell and Puls, 1997; Alowitz andScherer, 2002), b… 相似文献
9.
采用化学氧化还原-中和-絮凝沉淀法处理电镀废水中铬,研究了还原pH值、絮凝pH值、絮凝剂的用量、沉降时间对处理效果的影响。还原六价铬的最佳pH在2.0-2.2之间时,絮凝最佳pH值为9时,加入PAM,絮凝时间为0.5小时絮凝效果最好,处理后的Cr浓度最小。 相似文献
10.
高铬铸铁件生产中的质量控制 总被引:1,自引:0,他引:1
施建雄 《辽宁科技学院学报》2000,2(2):11-13
论述了高铬铸铁件生产过程中关于质量控制方面的几个关键问题,并详述了控制质量的具体措施。 相似文献